Microcontrollers
Design is a top-down process
-
Answer the big questions: RISC v. CISC, Harvard v. Von Neumann
-
Answer some medium questions: instruction set, addressing modes, mapped I/O or not
-
Answer some specific questions: memory organization, specific I/O port design
Internal memory organization
How many registers?
-
Depends on CISC/RISC and memory size
-
PIC16C73: registers are the RAM (192 8-bit registers)
What registers are needed for the control unit?
-
Instruction register
-
PC [Pic = PC, PCLATH]
-
Stack registers
-
Status register
What registers are needed for the data path?
-
Temporary holding registers [PIC = all registers]
-
Accumulator [PIC = W register]
-
Ports for I/O
-
Indirect address register
What special-purpose registers exist?
-
Accumulator
-
Stack
-
I/O ports
-
Status register
-
PC
-
Instruction register
How are the registers connected?
-
Most are connected by a single bus
-
PIC: since the W register always must be one of two binary arguments, don't need to move more than one item on the bus at any specific time
I/O organization
Memory-mapped I/O versus an I/O instruction set
6811 - I/O instruction set
PIC - memory-mapped
I/O functions are register controlled
I/O pin design for flexible use
A/D and input/output port
-
PortA: RA5, RA3:RA0 pins
-
configurable as inputs or outputs
-
configurable as digital or analog inputs
-
open wire to the A/D converter
-
AND gate to input latch, latch is input enabled on reads only
-
Logic connects output latch and register control latch to ouput CMOS drivers
-
PortA: RA4 pin
-
configurable as digital input or digital output
-
Schmitt Trigger input buffer isolates input and peripheral module from the pin
-
Open drain means the output can be connected in a wired-OR fashion (negative logic)
-
PortB: RB3:RB0
-
Has a weak pull-up feature, which means if the output pin is not connected to ground it will float high (if configured as an output
-
Output goes through a tri-state latch (TTL driver)
-
PortB: RB7:RB4
-
Also has a weak pull-up
-
Allows interrupt on change feature (can use it to wake up the processor when someone hits a key, for example)
-
Old value of the input is compared with the new latched value to see if there has been any change.
-
PortC: RC7:RC0
-
Can act as inputs or outputs
-
Can select between a peripheral output or the port C output
-
Peripheral input goes through a Schmitt trigger to isolate it from the pin
-
CMOS output driver
-
PortD: RD7:RD0
-
Simple configurable input/output pins