E21 Lecture #14

Project Planning

Current lab

How is this week's assignment going?

How are we going to create the brain?

Sensing with a computer

External stimulus -> sensor/transducer -> amplifier -> analog processing -> A/D converter

-> computer port -> software processing -> sensor output/decision-making

Example: Building a light sensor for a laser

  • Building a sensor with a photoresistor
  • Resistance decreases with increasing light levels
  • Need to convert ohms to voltage/current
  • Use a simple inverting/non-inverting op-amp circuit
  • Look at the gain (megaohms to 100 ohms) using a fixed feedback resistor
  • Set the power supply to an appropriate value
  • How do you deal with noise in the system?
  • Is there sufficient difference between the lights on/lights off and the laser that you don't need to worry about noise?
  • Do you need to shade the sensor?
  • Do you need to chop the laser at a high frequency and then integrate/low-pass the rectified AC signal?
  • How do you make a decision with the signal?
  • Analog logic that sets a TTL level: set the output to the integrated output, a low signal represents when the laser has been broken.
  • Let the op-amp saturate at 5V max signal
  • Make sure the op-amp does not saturate and has a low value when the laser is off
  • A/D convert and use software processing to make a decision: look at the signal over time and make a decision using a rule-based framework.

Example: motion sensor using ultrasonic transducers

  • Get a transmitter and a receiver
  • Pulse the transmitter with a big pulse (square wave, short duration, high voltage)
  • Sensing voltage across the receiver (connect one side to ground, the other to an op-amp)
  • Amplify the signal to a reasonable level
  • Integrate the signal so that the output of the system is a big peak whose maximum is directly related to the return time by some offset.
  • A/D convert the signal and take the maximum value as the return time
  • Do the calculations
  • Sound = ~300m/s
  • We want to resolve 5cm (theoretical limit is 0.5 cm)
  • Therefore, we need to be able to resolve the difference between peaks that are .05m / 300 m/s = .16ms apart
  • Therefore, we need to sample at least twice that frequency (~12kHz)
  • Then we come up with an equation D = (time + offset) * speed
  • offset is found using a calibration procedure
  • To use as a motion sensor, just look for significant changes in the distance. When the change is above a certain number, then activate the alarm/turn on the lights/whatever...

Next few classes

Thursday: patents

Second Exam: Tuesday

After that: PIC microcontrollers and we'll start looking at VHDL