E21 Digital Logic Design Lab #1

Due Thursday, 17 September, 1998

Purpose

The purpose of this lab is to familiarize you with a number of the standard SSI components, using a breadboard, and designing simple combinational circuits.

Rules on working together

For all of the labs in this course, up until we start the group projects, you may work with a partner. You and your partner can turn in a single lab report if you add short section describing the work each of you did. However, you must each keep your own personal lab notebook. When you create a circuit together, make sure you give appropriate credit to your partner in your notebook.

Task

The main task for this lab is to design and build part of the control circuit for a microwave oven. The newer models feature single button cooking options as well as the traditional "select your own time" method. You have been given the following task.

To "set the cooking time" your circuit needs to output a binary-coded decimal (BCD). This means you will have 4 output variables. You can then display the cooking time using a 7-segment display and a 7448 BCD decoder.

You should follow the following steps in creating your design:

  1. Create a truth table showing all of the possible inputs and all of the desired outputs.
  2. Create a Karnaugh map for each output and use it to find the minimal logic circuit.
  3. Draw the logic diagram using the standard symbols.
  4. Implement your logic diagram using the SSI chips in the lab.

Writeup

If you follow the above steps, you will have the majority of your writeup for this lab completed. Your E21 lab writeups will not be as long, or as formal as what you have had in other engineering courses. Clarity in your writeups is essential. What is important is that you convey what you have done in a clear and concise manner, and in sufficient detail that someone else could replicate your work.

In addition to the elements mentioned above, your lab writeup should include the following:

As noted in the syllabus, you should keep a lab notebook for this course. In this notebook you should keep diagrams of any circuit you build, along with enough information to replicate it. This is separate from your lab reports, but will be handed in for evaluation twice during the semester.

Other Notes

Be sure to follow the wire color conventions on this and all other assignments. Black connects grounded locations, red connections Vcc locations (usually 5V), and other wires can be used to keep track of various inputs and outputs. Breadboards can quickly become complex, so being organized up front will save you time in the long run.

You should probably use the switches on the breadboard to set your inputs. This will make it easy to switch inputs from one value to another.

7-segment Displays

For this assignment you should use the MAN 74 seven-segment displays with the green stripe. Do not use the ones with the red stripe, as they require external resistors to function properly. The pin-diagram for the 7-segment displays is given below.

From the top side of the chip with the green stripe to the right, the pins on the left side of the chip are numbered 1, 2, 4, 6, and 7 from top to bottom (3 and 5 are missing). The pins on the right side of the chip (the green stripe side) are numbered 8, 9, 12, 13, and 14 from bottom to top (10 and 11 are missing). The inputs to these pins are as follows:

  1. 7448 output f
  2. 7448 output g
  3. No pin
  4. Common ground
  5. No pin
  6. 7448 output e
  7. 7448 output d
  8. 7448 output c
  9. Decimal point
  10. No pin
  11. No pin
  12. Common ground
  13. 7448 output b
  14. 7448 output a

The input to the 7448 chip is the BCD value given by your circuit. The 7-segment display will then show the output of your circuit so that the user knows their beverage/popcorn will be ready at the right time.